External electric fuel pump relay wire transfer will take a small amount of planning. Find a place for the relay near the battery installation, convenient and easy wiring. 30 amprelay should be a relay and a 30 amp line fuse is necessary. Fuel pumps and chassis ground. For internal switch does not need a high rated current, because the relay is in use.

Help
1.the additional 10 rail lines - one line going, the positive wire from the battery to 30amp fuse in line and then to the relay. This wire should be connected with 10 gauge 16of the relay route. 16 dollars, and a more than 16 gauge the same length, should run intothe switch interior.

2.10 battery got 10 tracks with a yellow shovel connected to B + of the relay station.

3. the yellow spade connector, terminal, one of the ACC relay 10, the end line and run itback to the fuel pump. Attached to a docking connector yellow pump it. The second linefrom the switch connected to the relay with a blue southwest spade terminals.

4. line 16 attached to the relay ground terminal of the blue shovel, the other end have a good grounding terminal. Rolling along a fixed framework of the line all the way to the back line. Make sure the cord does not come into contact with any sharp or hot.

5.attached to a bottom connected to the light switch in the ground for a good length of the line. Another red wire connected to the fuse block positive line of the ACC switch.

Search: fuel pump,  oxygen sensor ,fuel pump assembly, module